The Dr. Dennis Gross DRx SpectraLite FaceWare Pro is an LED face mask with three selectable light settings. This owner guide focuses on setup and care documented by the manufacturer.
Start with a clean, dry face
The official quick-start guide says to cleanse and fully dry your skin before fitting the mask. Adjust its straps so it sits flush against your face. Toner or ampoule layering is not the starting step in this sequence: resume skincare after the session.
Select a setting
Hold the button for two seconds to power on, then use quick presses to cycle through red, blue and combined red-and-blue settings. The manufacturer labels these Anti-Aging, Anti-Blemish and combination modes. Those labels describe the options, rather than promising a particular result. The mask switches itself off after three minutes.
Care for the inside and outside differently
The manufacturer’s device support page gives more detailed cleaning instructions. Switch off and unplug the mask. Wipe the interior with an alcohol wipe or damp cloth. For the exterior, use a damp or microfiber cloth; avoid chemical or alcohol-based cleaners that could discolor its metallic panels. Let the mask dry completely before reuse. It cannot operate while plugged in.
Check which FaceWare Pro you own
The support page distinguishes first-generation and current masks when locating serial numbers: the inner left cheek for the former, and beneath the right-side strap hook for the latter. Keep that number and your supplied instructions available when contacting support. This guide does not assign one LED count or charging connector to every generation. Read the complete instructions supplied with your device for warnings and suitability before beginning.